The Firing Line Forums - View Single Post - Forster Co-Ax Primer Seater

**Unclenick** · July 16, 2009, 02:49 PM

Suwanee Tim,

I think you are right that he was talking about that. I assumed he was talking about the one built into the top of the Co-ax press. It uses the adjustable tabs like the one in your picture, but the ram mechanism works differently, providing that -0.004" below-grade seating I mentioned. It is also a put each primer in one-at-a-time setup, and does not use primer feed strips like the bench unit. The one built into the press, though slow to set up, is a good concept for military primer loading. The one in your photo is, as you say, not worth the inconvenience. I had one too. I can't recall if I gave it away or if it is gathering dust?

July 16, 2009, 02:49 PM	#10
Unclenick Staff Join Date: March 4, 2005 Location: Ohio Posts: 21,738	Suwanee Tim, I think you are right that he was talking about that. I assumed he was talking about the one built into the top of the Co-ax press. It uses the adjustable tabs like the one in your picture, but the ram mechanism works differently, providing that -0.004" below-grade seating I mentioned. It is also a put each primer in one-at-a-time setup, and does not use primer feed strips like the bench unit. The one built into the press, though slow to set up, is a good concept for military primer loading. The one in your photo is, as you say, not worth the inconvenience. I had one too. I can't recall if I gave it away or if it is gathering dust? __________________ Gunsite Orange Hat Family Member CMP Certified GSM Master Instructor NRA Certified Rifle Instructor NRA Benefactor Member and Golden Eagle