View Single Post
Old February 25, 2009, 01:11 AM   #3
Big Bill
Senior Member
Join Date: December 29, 2008
Location: Idaho
Posts: 1,053
When I got mine, I bought a handbook. Then I took it all apart and cleaned it. Then I sanded and refinished the stock. Next, I took the bolt apart and cleaned the parts of the bolt and checked the firing pin to make sure it was within tolerances (very important).

There are some good videos on YouTube that will explain most of it to you.
There is only one tactical principle which is not subject to change. It is to use the means at hand to inflict the maximum amount of wound, death, and destruction on the enemy in the minimum amount of time." - General George Patton Jr
Big Bill is offline  
Page generated in 0.03073 seconds with 7 queries