Thread: BAR bolt sleeve
View Single Post
Old February 22, 2009, 09:01 PM   #3
Junior Member
Join Date: February 22, 2009
Posts: 2
No idea. I got it off an auction site a few months ago. Figured i"d learn how they were put together before I fired it. Tore it down according to a book and found a small crack on either side of the sleeve about midway on it. The buffer was missing on the rod the inertia piece travels on too. Perhaps this was the cause. Do you know if replacements are available?
jethro222 is offline  
Page generated in 0.04396 seconds with 7 queries