View Single Post
Old November 23, 2008, 01:32 PM   #1
Junior Member
Join Date: March 9, 2006
Posts: 14
Problem with scope on S&W .460 Perf. Ctr.


I am using the factory-provided scope base and Warne 1" Maxima permanent rings to mount a Nikon 2.5-8 Monarch. To get the scope aligned anything close to point of impact, I have to rotate the windage all the way to the left (fully clockwise). I'm out of the adjustment range on the scope and still not where I need to be.

I tried moving the rings - swapping the side that they fasten from in various configurations but no change. I think the base only goes on one way, Any idea's what could going on or how to find out?

Theojt is offline  
Page generated in 0.05380 seconds with 7 queries