Thread: Lathe
View Single Post
Old October 22, 2008, 08:21 AM   #3
Join Date: March 4, 2005
Location: Ohio
Posts: 13,720
The only concern your choice gives me is that the spindle bore is under the diameter of some heavy barrel contours, so it would be too small to chamber those barrels through the spindle, and the bed is too short to set up to do it with a lathe dog and a steady rest. So, be sure you won't intend to have anything over 1" in the spindle.
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member
Unclenick is offline  
Page generated in 0.04840 seconds with 7 queries