Thread: Lathe
View Single Post
Old October 22, 2008, 06:19 AM   #1
Senior Member
Join Date: April 3, 2006
Location: Missouri
Posts: 398

I'm looking at getting a lathe to help with my gunsmithing hobby. I'm by no means a gunsmith but do like to tinker. I found one at Grizzly tools for about a grand. It's 10"x22" with a 1" spindle bore. Is there any certain features I should look for in a lathe for smithing? Any suggestions on one with out breaking my little piggy bank?
rickdavis81 is offline  
Page generated in 0.05590 seconds with 7 queries