View Single Post
Old October 20, 2008, 05:31 PM   #3
Harry Bonar
Senior Member
Join Date: December 5, 2004
Location: In the Vincent, Ohio general area.
Posts: 1,804

Yes, I'm sorry to say that an alloy frame willl eventially "dimple" in the feed ramp area and cause trouble. However, you need not be troubled becauise a good smith can mill for a piece of drill rod to be inserted and pinned and be shaped to the old feed ramp specs. I did one while working for Novaks 45 shop. You would need to find someone intimate with the 1911 to do it.
Harry B.
Harry Bonar is offline  
Page generated in 0.03060 seconds with 7 queries