View Single Post
Old October 26, 2006, 03:02 PM   #15
Bill T
Junior member
Join Date: September 19, 2006
Location: Glendale, Arizona
Posts: 298
Make sure the pin is centered in the die. Sometimes, depending how the die itself has been tapped, it won't center perfectly. If thats the case you can use thumb pressure to "persuade" it. You can easily check it by watching it as you screw the die into the press. The only other thing you can do is deburr the flash hole to help "guide" the pin into the hole. The problem is unless you have one of those motorized case prep centers, it's very time consuming to do with a large amount of handgun brass. It's almost cheaper and easier to buy a -CENSORED--CENSORED--CENSORED--CENSORED--CENSORED-load of decapping pins and live with it. Bill T.
Bill T is offline  
Page generated in 0.04797 seconds with 7 queries