Thread: neck tension
View Single Post
Old October 23, 2006, 08:42 PM   #6
Ammo Junky
Senior Member
Join Date: March 11, 2006
Location: IL
Posts: 537
FWIW, I aim for .0015" and accept .001 to .002 with bushing dies. With standard dies, They usualy give .002 to .003. I bought some preped 556 brass and they were .006" This was not good. I loaded them on a progressive and just ran them over an expander ball at the first station.
Will work for brass.

I apologise in advance for spelling errors.
Ammo Junky is offline  
Page generated in 0.04996 seconds with 7 queries