The Firing Line Forums - View Single Post - What diameter countersink bit for standard sling swivel studs?

Rimrock · March 4, 2006, 01:19 AM

"Drill a countersink hole with a 7/32 bit to a depth of 1/8. Then drill in the same hole to a depth of 1/2 with a 5/32" This according to the instructions on the Uncle Mike's label.

[IMG]

[/IMG]
Sorry about the huge pic.
Hope it helps!

Rimrock

March 4, 2006, 01:19 AM	#2
Rimrock Junior member Join Date: February 19, 2006 Location: CA Posts: 273	"Drill a countersink hole with a 7/32 bit to a depth of 1/8. Then drill in the same hole to a depth of 1/2 with a 5/32" This according to the instructions on the Uncle Mike's label. [IMG][/IMG] Sorry about the huge pic. Hope it helps! Rimrock