View Single Post
Old March 14, 2000, 06:34 AM   #6
Senior Member
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,270

Use them on my XL650.

Run the shell-plate up and screw the die down till it just 'kisses' the shell-plate, then lock down the die (you can put the lock ring both top OR bottom on the 650).

That adjustment does the sizing.

Then just turn down the top adjusting screw until you reach your desired crimp (remembering that crimp is NO SUBSTITUTE for adequate CASE NECK TENSION.)

"All my ammo is factory ammo"

WESHOOT2 is offline  
Page generated in 0.05363 seconds with 7 queries