View Single Post
Old November 25, 1999, 04:37 PM   #6
Senior Member
Join Date: October 15, 1999
Location: Colorado Springs, CO, USA
Posts: 653
In case anyone's interested, here's the reply
I received to my e-mail from Lee about this

"You could use the sizing die, but the expander die and the bullet seating
die are too 'deep' for the .38 cases. The .38 Special dies can be used to
load both calibers."

I've already re-sized and decapped a batch of
.38 Spl. cases using the .357 Mag. die with
no problem. Now I think I'll try to do the
rest of the process on one case just to see
what will happen. If it works, great; if
not, I'll just have to order a set of .38
Spl. dies from Midway.

Thanks to all who responded.

Reading "Capitalism: The Unknown Ideal," by Ayn Rand, should be required of every politician and in every high school.
DAL is offline  
Page generated in 0.07330 seconds with 7 queries