The Firing Line Forums - View Single Post

Harry Bonar · November 5, 2005, 10:26 PM

Dear "crowners"

Take a small peice of denin (blue jean material) cut a hole for the pilot and make sure material goes under the cutter and that will stop all chatter. Maybe two thickneses!
Do the same when you're reaming a smaller hole with a drill bit - use two or three thicknesses.
Harry B.

November 5, 2005, 10:26 PM	#12
Harry Bonar Senior Member Join Date: December 5, 2004 Location: In the Vincent, Ohio general area. Posts: 1,804	muzzle crowning Dear "crowners" Take a small peice of denin (blue jean material) cut a hole for the pilot and make sure material goes under the cutter and that will stop all chatter. Maybe two thickneses! Do the same when you're reaming a smaller hole with a drill bit - use two or three thicknesses. Harry B.