View Single Post
Old May 7, 1999, 07:28 PM   #3
Daniel Watters
Senior Member
Join Date: February 7, 1999
Location: USA
Posts: 644
This would be a good time to point out that the Double Eagle slide differs slightly from the Series 80 Government Model slide. The Double Eagle slide has the disconnector slot cut into the slide rail on the right hand side. A Series 80 slide can be remachined to work, but using a Series 70 slide would result in the disabling of the firing pin safety. Or you could just order a Double Eagle slide assembly from Gun Parts Corporation ( ). Part #SP57352 on page 285 is the stainless .45 ACP Government length Double Eagle slide; it runs $220.00 before shipping.

Other than the disconnector slot, everything else regarding the internals of the Double Eagle slide is either straight 1911 (barrel, barrel link, barrel link pin, barrel bushing, recoil spring guide, recoil spring plug, recoil spring, and firing pin spring) or Series 80 spec (extractor, firing pin, firing pin plunger, firing pin plunger spring, and firing pin stop).

BTW: You could fit .40 S&W, 357 SIG, 9x25mm Dillon, and .38 Super barrels to your 10mm slide. Spare magazines for the .40 S&W are being produced by Ed Brown ( ); these will also work with the 357 SIG. 9x25mm Dillon will work in the 10mm mags, and .38 Super mags are still available from several sources including Colt.

[This message has been edited by Daniel Watters (edited May 07, 1999).]
Daniel Watters is offline  
Page generated in 0.03493 seconds with 7 queries