View Single Post
Old August 23, 2002, 11:31 PM   #28
DAL
Senior Member
 
Join Date: October 15, 1999
Location: Colorado Springs, CO, USA
Posts: 653
How 'bout Clays?

I hope you don't mind me positing my own question on your topic.

I must confess that I am a lazy reloader when it comes to my handguns (my .30-06 is a different story--I measure each charge, trim the cases, experiment with powders and bullets, neck size, etc.). For my handguns I like to find one load that works reasonably well and stick with it. I have been using Clays for my .38 Spl. reloads to good effect (although it is a bit dirty), and I plan to start using it for my .45 ACP loads as well. My question is this: What about using Clays for the 9mm (whenever I start reloading for it)? It's pretty darn economical powder.

Well, it's off to the reloading bench to crank out a few hundred .38 Spl. rounds before I convert the Square Deal B to .45 ACP, something I've not done before (wish me luck).
DAL

P.S. BTW, I have read so many posts and articles in the past about WW231 that I may have to break out of my laziness and give it a try, along with the new, cleaner-burning Unique.
DAL is offline  
 
Page generated in 0.03143 seconds with 7 queries