PDA

View Full Version : Mosin-Nagant 1895 revolver


foxfire
January 20, 2002, 01:43 PM
Trying to remove the cylinder from an old, beat up, rusted one.

Yes, I realize that the re-arsenalled, surplus ones are a dime a dozen out there.
But I don't much about these revolvers yet, and want to start by trying to salvage this one.
Besides, it didn't cost me anything. :)

Any help or advice is greatly appreciated.


have tape, learning gun-smithing 101...;)

johelin
January 20, 2002, 03:16 PM
You have to get the cylinder rod away first by turning or pulling.

The revolver is Nagant's design, Mosin had no part in it.

foxfire
January 20, 2002, 03:49 PM
Thanks for the quick reply.
Does the rod come all the way out?
I can barely get it to come out even with the end of the barrel.
Guess I'll have to go get the hammer and chisel...



have tape, and can always put it back together...

cpileri
January 20, 2002, 03:57 PM
post your e-mail and I'll send the attatchment to you
Carl

johnwill
January 20, 2002, 04:45 PM
cpileri,

Why not just look in his profile, using the convenient button for that purpose? His email address is available there... :)

foxfire
January 20, 2002, 05:25 PM
Thanks John...

I went ahead and sent Carl an e-mail nevertheless.




have tape, and putting away my hammer...;)

cpileri
January 21, 2002, 09:14 AM
I am at owrk/lazy/ its more convenient this way/ I forget too easily/ etc. etc. take your pick