View Full Version : Who can anodize a Win. Aluminum Receiver???

dick w. holliday
May 23, 2001, 08:12 PM
i came by what i consider to be a real neat pair of guns this past weekend...They are a consecutive Ser # Win 1400 Skeet and a 1200 Trap..they were awarded by winchester in 1967 they are in very good condition but there is one problem--the owner scribed his drivers license # in the side of the receiver (Ouch!!!!). What i'm looking is someone how can do a like factory anodizing job on them after buffing out the DL #...Thanks in advance---Dick

May 26, 2001, 12:44 PM
I would try http://www.techplate.com

Very friendly and prompt replies to e-mail queries. Check them out!

May 26, 2001, 03:44 PM
Techplate, Inc. will hard anodize to milspec MIL-A-8625F. Go to their Finishes division and click on "hard anodize" or by milspec, MIL-A-8625F. Lots of color choices as well.

Good luck