View Full Version : SP01 owners, a question
chris in va
November 14, 2012, 11:30 PM
Could you measure your factory rubber grips? I'd like to find out if they would fit my 97b, even with a slight gap toward the front.
cogito
November 15, 2012, 12:37 PM
Can you tell me what precisely you want measured? Length, top width, middle, bottom, etc?
They're not a regular polygon, so a few measurements would be needed.
chris in va
November 16, 2012, 02:14 AM
Mainly width and length. I think it might (sorta) fit on my 97b, just wondering how much gap I'll have to accept.
I fitted the factory plastic 75b grip on it and there was some 'daylight' showing from inside the frame toward the front strap.
Basically just trying to find grips with the 'coke bottle' profile. CZ in their infinite wisdom decided to make the grips flat on the 97.
cogito
November 16, 2012, 10:50 PM
Width across bevel at the top: 1"
Width across top flare: 1 3/8"
Width at screw: 1 1/2"
Width at CZ log: 1 1/2"
Width at very bottom: 1 3/8"
Length across mid-line of grip: 3 3/4"
Of course, I may be off a bit here and there, but the above should be within 1/8th of an inch, probably more like a 1/16 margin of error.
(SP-01, standard/base model)
chris in va
November 30, 2012, 01:21 AM
Thank you very much!
vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.