PDA

View Full Version : EAA -10mm


dunerjeff
September 8, 2011, 12:23 AM
I ran across a EAA "STOCK" and it seems to be a really nice gun.It fit well and felt tight. It is in 10mm which is one of the calibers I've been collecting brass for(I figured when I had enough brass it's time to get a gun).I haven't seen to much on these as far as quality and reliablity or what is a decent price for them,it is new.They are asking $700 for it and said they have had it for a while so I may get it for less.

CWKahrFan
September 8, 2011, 01:59 AM
From the info I've gathered on the net, they have quite a good reputation.

For price comparison, here's a couple of links to Buds...

http://www.budsgunshop.com/catalog/product_info.php/cPath/21_231/products_id/411539807

and a more basic version...

http://www.budsgunshop.com/catalog/product_info.php/cPath/21_231/products_id/38878

ken2925
September 8, 2011, 09:15 AM
I have the compact version of the Witness line in 10mm. I have had no problems with this pistol(after breaking it in). At 30 ounces, full power loads are a little snappy, but it is a fine pistol. The ammo is higher priced than most other calibers, but I have bought a reloading kit and once I get it up and running I plan to do a lot more shooting with it. It had a break in point before it settled in to loading most JHP ammo. I believe I paid around $450.00 but that was several years ago. I hope this helps you out, KC.

Dave P
September 8, 2011, 10:10 AM
I sure like my Match version. Can ya get it for $500??

C0untZer0
September 8, 2011, 10:21 AM
The Witness Hunter seems like a fine pistol in 10mm

http://thefiringline.com/forums/attachment.php?attachmentid=71719&d=1309715855

dunerjeff
September 8, 2011, 12:19 PM
This one is all Stainless with ground sides,adjustable target sights ,double checkered front and backstrap,checkered wood grips,Match barrel,pretty nice trigger (not as good as a 1911 though).They have another one I think said "match" on the slide,stainless bottom with flat black slide,rubber grips,for $550.I put a colt 1911 over the top of it and the grip angle and size of the whole gun were basicaly the same.It felt a lot like my 1911. Buds has the same one for $750 so if I can get it for under $700 it should be good.I'm not too fond of black guns personaly(I work in a stainless shop) so this all SS is what I would rather get.

Get R Done Guns
September 8, 2011, 10:47 PM
EAA is a good gun. 10mm is the best part about it!! :D

jec
September 9, 2011, 12:33 AM
+1 for the EAA Hunter in 10mm. Great gun. Had mine refinished by Robar in NP3:
http://i3.photobucket.com/albums/y63/jcotterman/Guns/Hunter4-1.jpg

Skans
September 9, 2011, 07:33 AM
I have an EAA Stock 10mm. I can't say enough good things about it. It has one of the best da/sa triggers I've experienced. I find it easy to be accurate with this gun. It's a pleasure to shoot.....just wish 10mm ammo wasn't so expensive - I know, I need to start reloading again.

Here are some pictures of my Stock 10mm disassembled:

http://i209.photobucket.com/albums/bb218/Prichard_ac556/GunsBoo060.jpg

http://i209.photobucket.com/albums/bb218/Prichard_ac556/GunsBoo059.jpg

http://i209.photobucket.com/albums/bb218/Prichard_ac556/GunsBoo057.jpg

FWIW, $700 is a fair price for this gun. If its new - never been shot, that's a good price. I think I paid close to $700 for mine several years ago.

dunerjeff
September 9, 2011, 09:26 AM
That is the one right there^^^^,I'm heading over there this weekend and see about getting it,the fact that I haven't heard any complaints about it(even what little I knew of them before)says something.I don't need any dies or bullets for the 10 because I reload .40 S&W.So I'm all set up.