View Full Version : xdm
engineermike
June 21, 2011, 03:48 PM
I have a roll pin, on the top of the slide, of my springfield XDM that keep wanting to work it way out. I took it to a local gun smith and was told that springfield did not send them any roll pins and could not fix the problem. Any suggestion on how to keep the roll pin in or what pin might fit?
Doyle
June 21, 2011, 03:53 PM
Could you stake it in place?
GURU1911
June 21, 2011, 10:38 PM
1. Using the proper diameter "roll pin punch" do your best to eyeball the pin equally on both sides.
2. Put a drop of clear fingernail polish on one end of the pin & gently blow dry with a hairdryer.
3. Put a drop on the opposite end of the pin & let dry.
4. Repeat steps 2 & 3 again.
Guru1911
Entryteam95
June 22, 2011, 01:43 PM
I had the same problem, I contacted 'Powder River Precision'. They sent me 4 roll pins and I installed 1. Never had a problem since and the do an awesome trigger job also. :)
engineermike
July 5, 2011, 10:33 PM
I contacted Springfield after finding the striker retaining roll pin was broke. Springfield is sending my a new one tomorrow. If after a while it brakes too then I will contact Powder River Precision and try theirs. So far this is the only thing about the XDM that has failed but you would think that putting in a more durable pin would be high on their list of improvements. I'll replace the pin when the new one gets here and I'll see how it goes.
engineermike
July 10, 2011, 04:11 PM
Just got my striker retaining pin from springfield and installed it. Will see how long this one last...
vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.