View Full Version : I need a gunsmith in TX.....
Keg
May 20, 2011, 05:30 AM
I have several rifles..that I want to install recoil pads.....Anyone know a good one??? Reasonable would be OK too.....;)
Peter M. Eick
May 21, 2011, 02:59 PM
Where in Texas?
You know we are a reasonably big state and there is no point in telling you about a smith in Brownsville if you are in Amarillo.
Keg
May 22, 2011, 02:28 PM
Freestone County....90 miles south of Dallas....60 miles east of Waco....80 miles west of Tyler.....
GURU1911
May 23, 2011, 12:45 PM
Once you have found someone capable to re-pad your rifle stocks, take / ship only the stock--no need to ship the barreled action. I sincerely believe that in your area, there are several who could perform this chore for you.
Guru1911----native born (1951) to a texas family who has lived here since 1824 !!!
tazbigdog
May 27, 2011, 09:58 PM
I've done these before. Get the pad, line up the holes to the stock, pencil a mark, drill pilot holes and then screw them in. Good luck! Jeff:)
vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.