View Full Version : yet another question about my jp sauer & son western marshal 357 magnum s/a revolver
Hellbilly5000
April 19, 2009, 09:07 PM
I have found all but one part. I need a base pin for it and I was wondering if that base pin is the same size as another brand ( i.e. ruger ect.) and if they are interchangeable.
PetahW
April 20, 2009, 09:12 AM
If you have no other cylinder pin for a trial fit, have you measured the hole diameter & depth ?
A drill bit shank might get you close enough - or carry the cylinder to gunshows and ask the parts guys for a match.
James K
April 20, 2009, 03:27 PM
A base pin is usually an easy part to make if you can't find one.
Jim
vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.