PDA

View Full Version : T/C .50 Pennsylvania Hunter Detailed Breakdown


Atticus Thraxx
December 7, 2008, 12:36 PM
Guys, I've inherited several muzzleloaders and there's a fair bit of corrosion to address. The first one I want to do is the T/C .50 Pennsylvania Hunter. I need to pull the lock plate, rear site and trigger. Sure would be nice to have at best, detailed instructions and at least exploded digrams. I've emailed T/C but haven't heard back yet (it was 5 mins ago). I've done a web search but so far only found manual you get with rifle. Going to hit several forums with this.Any help would be appreciated.

Hawg
December 7, 2008, 01:38 PM
Pretty simple. Remove all the screws and it falls apart.:D I'm not familiar with the TC Penn. but from the pics I found it's set up basically like a flintlock Hawken. Hammer on half cock. remove ramrod and barrel wedge. Barrel lifts up from the front and has a hook on the rear. Lock has a single screw on the off side with a thick brass washer. Remove it and the lock comes off. You can remove it part way and tap the head of the screw to get the lock started out of the inlet. Remove the trigger guard and you can get to the screws for the trigger assembly. I think the rear sight is held by a single screw but not sure, may be two on a TC. Maybe somebody here has one and can tell you for sure but if I'm wrong it doesn't take a rocket scientist to tear down a muzzleloader. Just watch where each screw comes from so you can put them back in the right places.

Atticus Thraxx
December 7, 2008, 09:13 PM
Alright Hawg I'll give it a shot. Thanks.

arcticap
December 10, 2008, 01:39 AM
FWIW, here's a TC sidelock manual:

http://www.tcarms.com/assets/manuals/current/Shooting_TC_Side_Lock_Black_Powder_Guns.pdf