View Full Version : Ruger Mk II spring replacement

June 1, 2008, 08:20 AM
How do you replace the hammer and recoil springs on a Ruger Mark II? I wasnt to install Wolff replacemant springs.

Any links or detail directions will be great.


June 1, 2008, 03:18 PM
Recoil spring- Remove bolt, lift recoil spring out of notch in bolt, replace.
Hammer spring- Remove the mainspring assembly, drive out pin (careful or it will launch into orbit), remove factory mainspring, insert new spring, re-inatall follower, insert retaining pin.