View Full Version : Win 62A, Need Some Help
3StrikesNC
March 24, 2008, 08:03 PM
Posted elsewhere, trying to disassemble a Winchester 62A. Don't have a Manual, need one.
Stuck on removing the Foregrip as well as the Bolt.
Hawg
March 24, 2008, 08:24 PM
You have to remove the mag tube to remove the fore end. Can't help you with the bolt.
3StrikesNC
March 24, 2008, 08:26 PM
I took the pin out, but how do you get the tube out? Could it be rusted ?
Hawg
March 24, 2008, 09:08 PM
It's been a long time but if my memory is right it just slips in. Might be threaded but I really don't think so.
George R
March 25, 2008, 02:25 PM
HH is correct. It's just a slip fit. Maybe a little kroil or kerosene overnight will loosen it up. I can PM you an exploded view if that would help.
3StrikesNC
March 25, 2008, 06:08 PM
George; thanks, I have an exploded view from Steve's.
Am I correct, there is only one pin in the rear mag tube support?
3StrikesNC
March 25, 2008, 10:03 PM
I am redeemed!
Two days soaking in Liquid Wrench, an oak "drift" with a small hammer, and some courage supplied by TFL, .... and the mag tube came out without damage, the Foregrip is off, and the bolt is out.
Thanks. It is not threaded, just slips in.
Still looking for a Takedown Manual if anyone has one.
George R
March 26, 2008, 09:41 AM
I do have a receiver cross section that shows the relationship of the parts if you'd like that.
TEDDY
March 27, 2008, 09:15 PM
I just repaired one broken parts in carrier.every one should get the "GUN PARTS CAT"so many exploded parts prints.very useful.:rolleyes:-:confused:
:D---:D
vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.