View Full Version : highpower trigger pin
railroader
June 10, 2000, 12:59 AM
The fit between the trigger pin and the frame is starting to loosen up.I can see that the pin has moved a tad. How can I tighten the fit back up?(I had the pin out a couple of thousand rounds back when I took out the mag. safety)Thanks.
George Stringer
June 10, 2000, 08:31 AM
Railroader, take a cold chisel and hammer in 2 gooves about 1/8" long and 180 degrees apart on one end of the pin. This will expand that area and the pin should hold securely. George
vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.