View Full Version : Plastic Trigger on 1991A1

February 2, 2000, 09:13 PM
Hi guys I have this pistol in matte stainless steel and would like to dress it up a little. I would like to change the trigger and hammer. I would like to have your opinions on which work nice and how to fit them properly. A nice skelotonized trigger. I am a mechanic and work in thousenth's alot. Fitting is part of the fun.
thanks racer

George Stringer
February 2, 2000, 10:01 PM
Racer, the best trigger on the market, IMHO, is the Dlask Ultralight. Any hammer will work well if it's installed correctly. personally I like the Masen line in my own pistols. Just to save myself a lot of typing all the info you need for installation is at http://www.m1911.org/technic.htm. George

February 4, 2000, 08:44 PM
Thanks Goerge
I was looking at the Drask triggers and they look like they will do just fine. I just have to figure out what length. I hit on your link and came up file not found. Is this on the 1911 site. Thanks again.


February 4, 2000, 10:56 PM
Try this http://www.larue-targets.com/Extreme1911.html :)

"The Gun from Down Under !"
E-mail [email protected]
Alternate E-mail
[email protected]