PDA

View Full Version : Winchester Model 250 lever action 22 remove forearm


goresearch
October 10, 2005, 09:46 PM
I would like to clean some minor surface rust off of a Winchester Model 250 lever action 22. How do I remove the forearm?

Thanks in advance,

[email protected]

OneFreeTexan
October 11, 2005, 03:15 PM
Well, i have one at home and the forearm is off it already. I'm cleaning it. So when I get home this evening I'll look and let you know tomorrow.

OneFreeTexan
October 18, 2005, 10:29 AM
Sorry it took so long to get back, but I forgot which forum this was on.

Remove the tube under the barrel, there is a cross-pin under the front sight that has to be driven out.. Then the forearm should just slide forward about 1/2 inch and pop out. it is held in place by a metal piece which is in a slot cut into the under side of the barrel, just below the rear sight.

goresearch
November 2, 2005, 11:44 PM
Thanks for the info!

Bill