View Full Version : How to polish chamber?
April 30, 2002, 06:43 PM
I have a EAA Witness that has a rough chamber, I have already polished the feedramp, how do I polish the chamber? :confused:
Any suggestions would be greatly appreciated.
April 30, 2002, 11:21 PM
Cut a piece of 1/4" wooden dowel rod about 2-3 inches long and cut a slit in one end with a hacksaw. Then cut a 3/4" strip of #600 emery paper and put one end through the slot, wrapping the paper around the dowel, emery side out until it will just go in the chamber. Put the dowel rod in a drill and run it slowly for 10 seconds or so.
It may take 2 passes but shouldn't take more.
(Maybe needless to say, but remove the barrel and work from the chamber end; one guy asked if what I recommended wouldn't hurt the rifling when he pushed the rod through the barrel to the chamber.)
May 1, 2002, 06:47 AM
Crocus cloth; less abrasive.
Remember the mantra "I can take more off but I CAN'T put it back....."
vBulletin® v3.8.7, Copyright ©2000-2017, vBulletin Solutions, Inc.