View Full Version : Need Help ASAP Re: Ruger PC4 Carbine
April 6, 2002, 05:59 PM
Hey all, I just tore down my NIB PC4 to clean it in preparation for a range day tomorrow. When I tore it down, I found that the receiver washer was missing. I can call Ruger Monday but I'm sure it will take a week or two to get one. Can someone with a PC4 or PC9 give me the outside diameter and thickness of this washer so I can make one tonight?
Thanks for any help you can provide,
April 6, 2002, 07:25 PM
Unfortunatly I can't tell you that since I don't have one but I have gotten a recoil spring assembly from Ruger in 2 days the girl asked me if I needed it the next day for a shoot, she was gonna over night it to me if I did, I told her no, she said ok I will have it to you in about 2-3 days then.
I just ordered a grip panel locater for my Redhawk on Wed. and got it today.
And never charged me for any of the parts either.
This won't get you shooting tomorrow but at least you know it won't take as long as you thoght... HTH.
April 6, 2002, 07:55 PM
Thanks for the reply S.F.S.! Since I posted here, I've been frantlcly searching the Web and have found at least two individuals who say that the newest run of carbines come without the washer. You'd think they'd change the damn manual!
April 6, 2002, 11:42 PM
Change the manual? Anybody else ever notice that the drawing for the Mini-14 is for the 180 Series that feature an entirely different bolt hold than the 181 et seq.?
vBulletin® v3.8.7, Copyright ©2000-2017, vBulletin Solutions, Inc.