PDA

View Full Version : questions about a ak47


chadstrickland
April 20, 2011, 04:26 PM
Lol ok..I had this posted in the rifle thing but then it dawned on me that may have not been the correct place to post..so ill do it on both..I was wondering if I could use some of my romanian ak47 parts kits I got layin around the house and use one of those nodakspud receivers...( which they are hungarian ) so can my parts go in that receiver or not..and if some will and some wont..which will go and which wont...I dnt know if the pin holes are the same diameter or not..idk..:)

Dfariswheel
April 20, 2011, 05:47 PM
As long as you have an unfinished NoDak Spud receiver, most any AK parts will fit.
Where you might have trouble is with a receiver that's already had the trunnion holes drilled and won't line up with whatever kit you have.

chadstrickland
April 21, 2011, 10:57 AM
Thanks dude...ill have to check and see...if not I have the drawing for a romanian receiver...but im still not sure..if the holes are far enoug away from each other that I could drill new ones without cutting into the original holes....thanks tho

5.45 Shooter
April 26, 2011, 10:27 PM
As long as your receiver is not the Hungarian AMD 65 it will fit.
If it is the AMD 65 the only diferance is the rear trunnion.