Removing tokarev magwell spacer?

[BlueDragon]

Going to convert my 9mm tok to 7.62 by getting a new mag and barrel. but there is a spacer inside the magwell ive heard it's removable and it wiggles really bad so i assume it can come out? so what i have to ask is how do you remove it? pulling on it wont make it come out.:confused:

[BlueDragon]

delete thread i figured out how to do it:D

[yodarkritch]

I really dont understand why you'd wan t to mess with the magazine when it feeds both cartridges unmolested

My first CZ52 came with a replacement bbl. (9mm) and both 9mm and 7.62 x 25 were fed into the same magazine and the gun functioned perfectly with either barrel.



yodar

[BlueDragon]

Because the 9mm mags for the tok pistol are different from the original 7.62 tokarev mags and hense why the spacer is in the magwell to fit the thinner 9mm mags. i do know the 7.62x25 tok mags can fit 9mm rounds, however my 213 tok came with a mag strictly made for the 9mm. this is why i needed to figure out how to swap out the mags.