The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old January 7, 2002, 03:52 PM   #1
Kharn
Senior Member
 
Join Date: January 8, 2001
Location: Maryland
Posts: 1,531
Sanding the toe?

I've noticed several people talking about sanding the toe on shotguns for a better fit. I'm interested in doing the operation on my 12ga 870, as I currently get a less-than-perfect fit (heavy field loads are no fun what-so-ever and light dove loads get irritating after a few rounds, but my 8mm Mauser is a blast to shoot because the stock is very short and wide at the buttplate, only like 5"x2"). It probably doesnt help that I am 5'7", 180lb, and wear a 42short jacket (basically: I'm short and tubby in such a way that the toe of the 870 digs into my chest).

What exactly is involved in sanding down the stock, just go at it with a miniature belt sander until the recoil pad does not stick down below the wood, and has the same curvature? Before and after pictures would be a great help.

Kharn
Kharn is offline  
Old January 7, 2002, 07:50 PM   #2
Dave McC
Staff In Memoriam
 
Join Date: October 13, 1999
Location: Columbia, Md, USA
Posts: 8,812
It's not a question of sanding the stock, Kharn. If the toe of the PAD is digging in, a slight rounding will take some of the pain out. This works best for most women and barrelchested men. Use a belt sander or just a sanding block and take it slow. Doing too much will reduce the surface area in contact, thus increasing what we want to decrease.

Sometimes taking a little off the inside edge of the pad helps too. Again, go slow...
Dave McC is offline  
Old January 7, 2002, 08:54 PM   #3
Ledbetter
Senior Member
 
Join Date: February 23, 2000
Location: California USA
Posts: 4,535
I did this

to my Mossberg 590. What I did, which worked real good, was to eliminate the point and put an even radius there instead. I only worked on the outside of the pad. I sanded about 1/4" of the point off and then rounded. Do not remove so much material that the concave shape of the pad is affected.

Good luck
Ledbetter is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:09 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05613 seconds with 7 queries