The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old October 27, 2001, 03:06 PM   #1
Ed Dixon
Senior Member
Join Date: September 5, 2000
Location: Ireland
Posts: 308
Rash buy?

I got an RCBS Rockchucker Master Kit in the mail a few weeks ago. I haven't started using it yet, but have been picking up some other accessories and working through the NRA guide to reloading (already read ABC's of Reloading). I'll start with 45-70 cartridges for a rolling block repro. So far I've only shot 405-grain jacketed bullets and have about 140 cases saved. As a first set of dies I ordered the "cowboy" RCBS ones which mention that they also crimp. My question: are such crimping dies only really right for cast unjacketed bullets? Can they be used with some of the jacketed bullets I've already bought or should I get a non-crimping set for these and save the "cowboys" for the undressed lead which I'd also like to try out? Expect to pick up a Ruger Vacquero in 45LC soon, so this would likely apply there too.
Ed Dixon is offline  
Old October 27, 2001, 06:38 PM   #2
Senior Member
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,270

For crimping jacketed (and other) bullets highly recommend REDDING Profile Crimp die (available in both 45-70 and 45 Colt).
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  
Old October 27, 2001, 09:20 PM   #3
Senior Member
Join Date: August 13, 2001
Location: Montana
Posts: 489
If you are shooting your .45-70 out of a single-shot, no crimp required. Otherwise a roll crimp is required.

Your .45 Colt should always be crimped.
sricciardelli is offline  
Old October 28, 2001, 08:33 AM   #4
Join Date: March 27, 1999
Location: Lansing, MI
Posts: 86
Yes you can crimp lead or jacketed with that die. The jacketed bullets should have a crimping cannelure to crimp into.

Doctari is Doc on Safari
Doctari is offline  
Old October 28, 2001, 11:03 AM   #5
Senior Member
Join Date: December 30, 2000
Posts: 699
As was stated you do not need to crimp if used in a single shot.

I do reccomend that you, as a seperate step, remove the belling of your case. This will prevent off center placement of the round in the chamber due to the belling.
KP95DAO is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:57 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06465 seconds with 9 queries