The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old August 14, 2001, 05:13 AM   #1
mundumugu
Member
 
Join Date: July 12, 2001
Location: Brazil
Posts: 46
o.a.l. of handloads

In various loading manuals, I have seen different O.A.L of .357 mag cartriges, and in others too. Also, some very different max. loads. An old speer man. gives 17.5 grains of H110 for a 180 gr. bullet, Lyman gives 15.0.
O.A.Ls for a 180 gr. bullet varied from 1.550 to 1.595.
Now, what? any help is apreciated. I intend to load 180s cast truncated cone that, in my handloads, measure 1.55" o.a.l., and 15 gr. of H110. thanks in advance.
mundumugu is offline  
Old August 14, 2001, 05:28 PM   #2
Chris McDermott
Senior Member
 
Join Date: March 30, 2000
Posts: 245
OAL depends on the bullet shape & where the crimp groove is (if you use it); more than a bullets weight. Bullets with a short nose, that put most of the bullet inside the case, will have a short OAL, and also a lower max powder charge as there is less room in the case for powder. Bullets with a long nose will have more of the bullet outside the case, and so have a long OAL and a heavier powder charge as there is more room in the case for the powder - not just room for the powder to fit in, but also a larger space to hold the resultant gases [go back to your high school chemistry - if you have the same amount of gas molecules from burning the same amount of powder, the more space those gas molecules have to move in the less pressure & temperature; to maintain a given pressure in a larger space you need more molecules, so you use more powder].

You can either follow the manual that lists the exact bullet you have (a good reason to have a load manual by your favorite bullet manufacturer), or start low and gradually work up your load, watching carefully for pressure signs.
Chris McDermott is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:24 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05490 seconds with 7 queries