The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old May 6, 2001, 01:50 PM   #1
Rock
Member
 
Join Date: July 2, 1999
Posts: 25
Anyone know if Rainier bullets are ok in Glocks or must one use jacketed bullets when reloading for them
Thanks Rock
Rock is offline  
Old May 6, 2001, 03:19 PM   #2
WESHOOT2
Senior Member
 
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,240
When loaded to modest velocity the Rainier delivers excellent accuracy from Glocks (in 9x19, 40S&W, and 45ACP).
__________________
.
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  
Old May 7, 2001, 08:27 AM   #3
Master Blaster
Senior Member
 
Join Date: October 11, 1999
Location: One of the original 13 Colonies
Posts: 2,027
I loaded Berry's plated 124gr bullets with 4 grains of titegroup, about 1,000 fps out of a G-26 and No Fouling. The plated bullets work great in my factory barrel.
Master Blaster is offline  
Old May 7, 2001, 09:27 AM   #4
skevlar
Senior Member
 
Join Date: September 11, 2000
Posts: 327
Yup, have run ca. 2K thru a G34 in IDPA, etc. Good accuracy and no problems. Bore stays very clean along with using Titegroup.
__________________
"You can not invade mainland United States. There would be a rifle behind each blade of grass." Admiral Yamamoto
skevlar is offline  
Old May 7, 2001, 07:39 PM   #5
Swamp Yankee
Senior Member
 
Join Date: November 26, 2000
Location: Northeastern Ct.
Posts: 1,013
I have shot lots of Rainier 115 and 124 gr PRN in my Glock 19 with the only problem being it keeps asking for more. Also have had very good luck with the Rainier 124 gr PFP in .357 Sig practice ammo. Currently use West Coast 124 gr. PRN in 9mm. They seem a little more consistant than the Rainiers.
Take Care
Swamp Yankee is offline  
Old May 8, 2001, 02:25 AM   #6
Wayward
Member
 
Join Date: November 18, 2000
Location: Texas
Posts: 79
I've been using Berry's 124rg flat points for both 9mm and 357 sig. 13.2gr of AA9 for 357 sig and 6gr of Power Pistol for 9mm. I've seen no signs of excessive fouling with either load out of my Glocks.
Wayward is offline  
Old May 8, 2001, 11:52 AM   #7
Rock
Member
 
Join Date: July 2, 1999
Posts: 25
Thanks for the info I will tread lightly
Rock
























Rock is offline  
Old May 8, 2001, 05:39 PM   #8
jtduncan
Senior Member
 
Join Date: December 5, 1999
Location: Seattle, Washington, USA
Posts: 1,681
The Rainier have worked fine for me in 9mm, 10mm, and 45 ACP. Accurate and cheap. Just don't try to load them past 1600 fps!
__________________
The Seattle SharpShooter - TFL/GT/AR15/SGT/PCT/KTOG/SWF/RF/HKPRO/OA2/1911Forum
Reloaded .223 Rem, 9mm, 40SW, 357 SIG, 10mm, 44 Spl, 44 Mag, 45 ACP Today?
jtduncan is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:51 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07674 seconds with 7 queries