The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 20, 2001, 07:10 PM   #1
Redneck2
Senior Member
 
Join Date: April 24, 2000
Location: Northern Indiana
Posts: 519
Just got some new Winchester 22-250 brass. Going to load for a PD hunt. Is it worth the trouble to neck size on new brass? I know that for the BR buys that need the extra .1 everything helps. How much does it help to keep in "minute of 'dog" or does that depend on the particular rifle (it's a 700 VS).
Redneck2 is offline  
Old March 20, 2001, 07:44 PM   #2
Southla1
Member In Memoriam
 
Join Date: March 19, 2000
Location: Jeanerette, La. Near the
Posts: 1,999
Its always best to size new brass and chamfer it before loading it the first time. I always neck turn mine for all my rifles not just the 22-250. I set the depth on the turner (Forster) just deep enough to make the necks concentric. This makes the bullet tension the same (hopefully ) from case to case without removing any brass to speak of. I find that it does not necessarly tighten groups but it seems to help eliminate some flyers.
Southla1 is offline  
Old March 22, 2001, 05:52 PM   #3
Big Bunny
Senior Member
 
Join Date: August 9, 1999
Location: New South Wales - Australia
Posts: 605
I would fire them a few times - RN2- with scotch-taped head(the first time) and neck size only/chamfer/check for length - at the range and then centralise flash-hole with Lyman tool and then outside neck-turn with the minimum of brass shaved off before re-loading.
Big Bunny is offline  
Old March 22, 2001, 06:08 PM   #4
Bogie
Senior Member
 
Join Date: June 5, 2000
Location: Job hunting on the road...
Posts: 3,827
Disclaimer: I shoot benchrest.

Best accuracy from a factory chamber. Fire form 'em with a starting load, with the bullet jammed hard. Bolt should close hard on the unfired round, since you're jamming the bullet into the lands.

If you're brass is halfway decent, you won't need to turn it. Find someone with a Neco gauge, or something similar, and check it out. If it doesn't vary too much, leave it alone.

FWIW, I shoot unprepped (except for flashhole and primer pocket) Winchester .22-250 brass in one of my Savages, and with 55 gr. Berger MEFs and H380, it'll agg in the mid-threes...

Bogie is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:22 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06008 seconds with 7 queries