The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old February 24, 2001, 01:29 PM   #1
Coop de Ville
Senior Member
 
Join Date: April 14, 2000
Posts: 436
I recently purchased a new 11-87 Police model. It has ghost ring sights, bead front from Gunworks? Both the bead and the rear ap. have wings ("It's got wings!" The rear wing/ghost ring assembly is silver soldered? to the receiver. Now, it was soldered crooked, a little to the right. The ring has been adjusted so it shoots straight. It is really a cosmetic thing more than anything. Do you think a smith could unsolder/resolder it, or at some point remove it if I decide to change sights? Thanks and regards -Coop
Coop de Ville is offline  
Old February 25, 2001, 08:16 AM   #2
Dave McC
Staff In Memoriam
 
Join Date: October 13, 1999
Location: Columbia, Md, USA
Posts: 8,812
Yup, Coop, a decent smith could. However, it works,right?

FIRST RULE OF ENGINEERING:

If it ain't broke, don't fix it.

Dave McC is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:11 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05491 seconds with 7 queries