The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old January 31, 2001, 06:03 PM   #1
alowishious
Junior Member
 
Join Date: January 30, 2001
Posts: 6
Are there any on the market that fit without the need for a gunsmith. I spoke with the folks over at Ashley Outdoors and in order to install their product you have to remove the Moss bead and drill out the hole and thread it for a Remington size bead. I'd like to avoid this if possible. Thanks for any advice.


alowishious is offline  
Old February 1, 2001, 02:24 AM   #2
DML
Senior Member
 
Join Date: November 24, 2000
Location: Aridzona
Posts: 257
I don't know for sure what the screw size of the Mossberg bead is, but it is smaller then 6-48. (It may be 5-40) There are various tritium beads on the market, but I think most of them have a 6-48 thread.

If you have any mechanical aptitude, you should be able to install one of these sights, but it would probably be more cost effective to have a gunsmith install one if you don't have the tools. (#31 drill, 6-48 tap, drill motor, file, etc.)
DML is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:37 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05399 seconds with 7 queries