The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 30, 2001, 12:32 PM   #1
2cats
Member
 
Join Date: October 3, 1999
Posts: 56
How much of a dent in the case mout can be tolerated before you have trouble with the resizing die? What remediation do you do?

Many thanks,
__________________
2cats

Glock 19
Glock 17
Colt Police Positive .38 Special
Smith & Wesson Model 41
Browning Hi-Power Standard (9mm)
2cats is offline  
Old January 30, 2001, 01:01 PM   #2
Quantrill
Senior Member
 
Join Date: February 28, 1999
Location: Arizona, USA
Posts: 725
Dented Mouths

2 Cats, (neat name)
Put the dented cases in the resizing die. Chances are that will get rid of the dents. If it doesn't, don't reload just yet, try putting it in the mouth expander die. If that gets rid of the dent, just run it through your regular reloading process. If it doesn't toss it out. Quantrill
Quantrill is offline  
Old January 30, 2001, 01:57 PM   #3
Kenneth L. Walters
Senior Member
 
Join Date: September 2, 1999
Location: flagstaff, arizona
Posts: 476
On REALLY extensive dents, like where someone ran over them with a truck, I just use plyers to more or less get the mouth round and then a case mouth flairing die to get it shaped correctly. Very few cases have to be tossed for this.
Kenneth L. Walters is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:30 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06169 seconds with 7 queries