The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools
Old February 14, 2014, 10:09 AM   #1
Senior Member
Join Date: May 25, 2007
Location: South Florida
Posts: 879
Nut needed

The grip retaining nut for my 1944 (CZ) Duo .25 auto is missing. The retaining screw
is 2.5 mm X 0.45 tpm.
Any suggestions as to where to find one aside from the usual suspects like Numrich?

Trigger control + Breath control + Sight alignment = Gun Control.
NRA Smallbore Prone Master
velocette is offline  
Old February 14, 2014, 11:58 AM   #2
Dixie Gunsmithing
Join Date: April 27, 2013
Location: Ohio
Posts: 1,545
Wasn't that practically a copy of the Colt 25 hammerless? If so, you might be able to convert the grip hardware. To convert, you'll need both the escutcheon nut and screw.
Dixie Gunsmithing is offline  
Old February 14, 2014, 03:24 PM   #3
Join Date: June 16, 2009
Posts: 79

Kings Bolt
4680 N Grand Ave
Covina, CA 91724
(626) 339-8400

Southern California
Anything legal, Rifles, Handguns, Shotguns, Black powder
john323 is offline  

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:36 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04764 seconds with 9 queries