The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old February 9, 2014, 04:40 PM   #1
Swilly
Member
 
Join Date: January 14, 2014
Location: Central, WI
Posts: 18
Loose fit on lyman sight

I've been putting together a rifle from a turkish mauser action using a green mountain blank. I really wanted to put a lyman 57 rear sight and lyman 17 front. I finally got the dovetail cut in the barrel and front sight installed last night. After firing it a bunch and adjusting the rear trying to get it zeroed I noticed that the slide on the rear sight is slightly loose in the base that is screwed to the receiver causing it to wiggle around. I am frustrated! Has anyone else experienced this? I have not contacted the distributor I purchased the sight from yet nor have I contacted lyman. Just wondering if this has happened to anyone else.
Swilly is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:45 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06216 seconds with 7 queries