The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old November 9, 2013, 07:56 AM   #1
Senior Member
Join Date: June 25, 2006
Location: the Garden State
Posts: 897

Has anyone tried to neck down 257 Roberts to 6mm Remington?
"The Constitution is not an instrument for government to restrain the people, it is an instrument for the people to restrain the government, lest it come to dominate our lives and interests."
Patrick Henry, American Patriot
ammo.crafter is offline  
Old November 9, 2013, 05:46 PM   #2
Paul B.
Senior Member
Join Date: March 28, 1999
Location: Tucson, AZ
Posts: 2,873
Should be a very simple process. Just lube the brass and run them through the sizing die. Check OAL to be sure they didn't stratch too long and trim if necessary.
Paul B.
Paul B. is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 11:53 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.11221 seconds with 7 queries