The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old October 13, 2013, 12:56 PM   #1
napg19
Senior Member
 
Join Date: December 5, 2009
Location: Arkansas
Posts: 354
FEG magazine release

I have a Hungarian FEG AP 7.65 Browning with a magazine release that's hard to push in. I have spayed cleaner in it and oiled it and still the same. How do you take the mag release out of the gun so I can check out this problem? I cannot find any instructions online. Any help's always appreciated. Thanks.
napg19 is offline  
Old October 15, 2013, 12:07 PM   #2
BoogieMan
Senior Member
 
Join Date: April 4, 2012
Location: South Jersey
Posts: 1,287
Do you mean a PA63? Not familiar with a ap. All bottom release mags I have ever had are tough to release including my PA63 and Frommer Stop. If you think that debris has fouled up the spring than remove the grips and look for the pin that retains the spring mech.
__________________
Concentrated power is not rendered harmless by the good intentions of those who create it.
Milton Freidman
BoogieMan is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:46 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06156 seconds with 7 queries