The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old August 27, 2013, 02:56 PM   #1
Senior Member
Join Date: April 15, 2005
Posts: 167
Marlin 100G extractor

Being a sucker for old .22 single shots, I picked up a Marlin 100G over the weekend.

Pleased with my purchase, I went home and set up some empty soda cans. Unsurprisingly, the rifle was dead on. Surprisingly, I had to shake the spent case out.

Apparently I overlooked the fact that the extractor was missing. I'm ordering one from Numrich in the next week or so. How do I go about installing the replacement extractor?
Kilroy08 is offline  
Old August 27, 2013, 08:00 PM   #2
Dixie Gunsmithing
Join Date: April 27, 2013
Location: Ohio
Posts: 1,589
There is a small pin that goes through the front of the bolt that holds it in. Drift out the pin, and remove the old one, and watch to not lose the spring.
Dixie Gunsmithing is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:59 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05249 seconds with 7 queries