The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old September 12, 2013, 04:08 PM   #1
old fart
Senior Member
 
Join Date: May 24, 2009
Posts: 296
frame pin not even?

i have a nef pardner sb1 11c, its the one with nickle receiver and synthetic stock and forarm. i noticed today all my frame pins are even on both sides except one, the one on top that goes across and hold the fireing pin and ejector button. was sticking out more on one side it is very noticable, can these move? i have been shooting buckshot and slugs in it. can i tap it back in? if so with what? i have went online to look at pictures and some seem like mine while others look all even. do ya'll think the pin moved or just wasn't tapped all the way thru at factory?. thanks
old fart is offline  
Old September 12, 2013, 06:01 PM   #2
Old Stony
Senior Member
 
Join Date: May 31, 2013
Location: East Texas
Posts: 695
Probably left out that way from the factory. Just take a brass or nylon punch and tap it all the way in.
Old Stony is offline  
Old September 12, 2013, 07:18 PM   #3
old fart
Senior Member
 
Join Date: May 24, 2009
Posts: 296
i went to my local shop and looked, some are like mine. the one side is even with the hole at the frame, and on the other the pin is past the hole on the frame.
old fart is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:49 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05951 seconds with 9 queries