The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old September 21, 2013, 08:17 PM   #1
NHSHOOTER
Senior Member
 
Join Date: November 26, 2012
Location: Concord NH
Posts: 322
adjustable rings?

I just bought a new to me used model seven remington, it came with rings, no scope.
My question, the rear ring has a large screw on each side down by the block where it mounts to the reciever and there are no large screws on the front ring. Are these adjustable rings for windage?
NHSHOOTER is offline  
Old September 22, 2013, 04:51 AM   #2
mxsailor803
Senior Member
 
Join Date: February 8, 2010
Location: Norfolk, Va
Posts: 816
They are used for centering the ring in the receiver and align with the front ring. I use a scope alignment rod to get it as close to perfectly align as I can. You can get by using a 1" wooden dowl rod as well.
mxsailor803 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:40 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06032 seconds with 9 queries