The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Thread Tools Search this Thread
Old July 2, 2013, 09:55 PM   #1
Junior Member
Join Date: February 19, 2013
Posts: 13
Warner Arms Hammerless Snubbie

Does anyone know where I might find a drawing or schematic for the Warner arms 38S&W hammerless snubby. I am having problems putting the Main spring back in the right place
Dstarver is offline  
Old July 4, 2013, 07:18 PM   #2
James K
Join Date: March 17, 1999
Posts: 22,066
My memory is not what it once was, but IIRC that revolver uses the flat mainspring common to revolvers of that era. If so, it is a sort of shallow U with the tip of the longer part fitting into a notch in the bottom of the hammer and the shorter end going into a notch in the bottom of the grip.

Installing the mainspring is just a matter of bending it to fit both ends where they need to go.

If that is not correct, please post a picture of the gun with the grips off and the spring you are trying to install and maybe we can help.

Jim K
James K is offline  
Old July 5, 2013, 09:00 AM   #3
Senior Member
Join Date: September 28, 2008
Posts: 7,149
If it has a flat mainspring, it helps to bend it around something like a dowel that's put between the front of the grip frame and the spring.
Lock the doors, they're coming in the windows.
g.willikers is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:01 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04294 seconds with 7 queries