The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools
Old May 21, 2013, 04:55 PM   #1
Junior Member
Join Date: May 20, 2013
Posts: 3
Remington model 1100 operating lever coming out

Hi Guys!
What would be the cause of the operating lever sometimes coming out in recoil and cycling?

This is an older gun with lots of skeet and trap shooting in its history.

Thanks in advance for your opinions.

Sharkey453 is offline  
Old May 21, 2013, 05:56 PM   #2
Senior Member
Join Date: September 28, 2008
Posts: 6,811
The operating handle is held in place by a detent ball and spring in the action bar assembly.
Here's a video of disassembly with a reference to it:

Here's a schematic showing the parts.
Look for the parts numbered 69 and 70, in the action bar assy, (part number 1):
Lock the doors, they're coming in the windows.
g.willikers is offline  
Old May 21, 2013, 08:58 PM   #3
Junior Member
Join Date: May 20, 2013
Posts: 3
Model 1100 operating handle problem

Many thanks g.willikers!

I have actually disaasembled my 1100 as shown in the video, but I wasn't exactly sure about the ball detent and spring situation that keeps the operating handle in place.

I'm supposing the ball has developed a flat spot over the years, or maybe the spring has lost some tension.

I probably should order replacements if they're available.

Thanks again for the swift reply!

It's a pleasure talking with folks with savvy!

I'm a retired prototype machinist so I'm not afraid to go the rest of the way to check everything out.
I just thought maybe there was some simpler solution.

This is a swell site, wish I had joined earlier!

Sharkey453 is offline  
Old May 21, 2013, 10:35 PM   #4
Senior Member
Join Date: January 9, 2013
Posts: 278
They made those two different ways. One had a spring loaded plunger behind the handle and the other had a ball under it instead. The later replacement handles have provision for both and are interchangeable. Be sure you don't have an early handle that isn't right for your action bar.
oldgunsmith is offline  
Old May 22, 2013, 01:57 PM   #5
Dixie Gunsmithing
Join Date: April 27, 2013
Location: Ohio
Posts: 1,546
Check the detent spring for being dirty, or weak. Those detent balls are hardened, so I would look at the spring first. Second, check to make sure the detent in the handle isn't wallowed out, and not allowing the ball to hold it tight enough.
Dixie Gunsmithing is offline  

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:54 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06699 seconds with 7 queries