The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Art of the Rifle: Semi-automatics

Reply
 
Thread Tools
Old May 19, 2013, 12:00 AM   #1
American Red Neck
Junior member
 
Join Date: May 8, 2013
Posts: 81
Sig M400 First Shots

Today I was finally able to take my new sig m400 out and break her in. I have shot many new ar-15's and I must say this m400 performed flawlessly without out one failure. Very, very accurate. I know Iv'e been asking a lot of questions about changing the barrel and bcg and this and that but I am pretty comfortable with it in its stock configuration. Damn this thing is so bad ass. I did do one mag dump to put some heat to her and got the gas tube to smoke for a short second, I think it was the factory grease burning off. I just got done doing a bit of a trigger job on it (not that it needed it but I'm tinker man)...I am just speechless and in aww about how nice this thing is..Guys I come from a long line of Ak use and recently switched to the ar platform and wish I would have done so earlier.
American Red Neck is offline  
Old May 19, 2013, 03:12 PM   #2
Fishbed77
Senior Member
 
Join Date: November 23, 2010
Posts: 2,690
Quote:
I know Iv'e been asking a lot of questions about changing the barrel and bcg and this and that but I am pretty comfortable with it in its stock configuration.
We all figured that would be the case when you actually shot it.

All a rifle like that needs is a good sling and plenty of ammo.
Fishbed77 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:15 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06221 seconds with 9 queries